|
Different ways to order an Aluminum Safety Spa Cover All Measurements
should be in inches.
GOOD METHOD:
Give us the spa size outside dimensions (of lip) and inside
dimensions of (water line, and we will make the cover
one (1) inch smaller than the outside dimension, so that
the cover will rest on the lip of the spa. This will be one-half
(1/2) inch on each side.
BEST METHOD:
The best method is to make a template of the spa.
A. Purchase a clear plastic painter's drop cloth from a
hardware or paint store, (thicker is easier to work with, must
be at least 1 mil thick or it will stretch.)
B. Stretch plastic over spa and pull tight, so there are no
wrinkles or bubbles and secure to side of spa using tape.
C. With a felt marker:
1. Mark plastic "This side up"
2. Trace the outside (O.D.) of shell on all sides
3. Trace inside (I.D.) of shell on all sides. If the spa is
built in, indicate this as the waterline.
4. Trace an outline of controls and anything on top of spa lip
that might hinder a good seal.
5 Keeping in mind that the seal must rest on a flat surface to
seal correctly, mark where you would like the cover to rest
with a dotted line. If you are not sure, skip this step and we
will determine it for you.
6. With dotted line mark where you would like the hinge.
If no markings, then we will pick the location.
|
